Hustler Turf ATZ - Manual (Page 7)

Hydraulic fluid escaping under pressure
can penetrate skin.
Hydraulic fluid may also cause infection in
a minor cut or opening in the skin; if
exposed to hydraulic fluid, see a doctor at
once.
Before applying pressure to hydraulic
system, make sure all connections are
tight and all hoses and lines are in good
condition.
Relieve all pressure in the system before
disconnecting or working on hydraulic
lines.
To find a leak under pressure, use a
piece of cardboard or wood – never use
your hands.
To relieve all pressure in system, turn
engine off and lower attachment.
601656_0308
Avoid skin contact with battery acid.
Always wear eye protection when
checking the battery, acid can cause
serious injury to skin and eyes. If contact
occurs, flush area with clean water and
call physician immediately. Acid will also
damage clothing.
Do not allow open flame near the battery
when charging.
Hydrogen gas forms inside the battery.
This gas is both toxic and flammable and
may cause an explosion if exposed to
flame. Always remove the negative
ground first and replace it last.
Do not overfill battery.
Electrolyte may overflow and damage
paint, wiring or structure. When cleaning
the battery, use soap and water. Be
careful not to get soap and water into the
battery. Use soda mixed in water to clean
corrosion off the terminals.
Keep engine and pump compartment(s)
clean (especially in exhaust area) to
prevent fire and provide maximum engine
and hydraulic cooling.
Avoid crushing
Do not jump if machine tips
Use seat belt
Seat belt must be fastened while
operating this machine. Failure to use
seat belt will result in serious injury in the
event of a roll over.
This structure’s protective capability
may be impaired by structural damage,
overturn, or alteration. If any of these
conditions occur, this structure must
be replaced.
Avoid crushing, use seat belt.
Do not jump if machine tips.
To minimize chance of injury or death
from rollover; keep ROPS in the raised
and locked position and use the seat
belt.
Never operate machine on a slope with
the ROPS folded down (lowered
position).
There is no roll over protection when
the ROPS is in the lowered position.
Lower the ROPS only when absolutely
necessary. Drive slowly and carefully.
Raise the ROPS as soon as clearance
permits. Read and follow slopes
operation instructions and warnings.
Do not wear seat belt when the ROPS
is in the lowered position.
6
If you loose steering control while
operating the machine, place the steering
control levers in the park brake position
immediately. Inspect the machine and
involve your Hustler dealer to resolve the
problem before continuing to operate.
If pump belt fails, steering control will
be lost. Refer to owner’s manual for
inspection and replacement intervals and
refer to above paragraph for emergency
procedures.
If you lose steering control while operating the machine, place the steering
control levers in the park brake position immediately. Inspect the machine and
involve your Hustler dealer to resolve the problem before continuing to operate.
If pump belt fails, steering control will be lost. Refer to owner’s manual for
inspection and replacement intervals and refer to above paragraph for
emergency procedures.
600899
Part Number
600899
601635
This structure’s protective capability
may be impaired by structural damage,
overturn, or alteration. If any of these
conditions occur, this structure must
be replaced.
Avoid crushing, use seat belt.
Do not jump if machine tips.
To minimize chance of injury or death
from rollover; keep ROPS in the raised
and locked position and use the seat
belt.
Never operate machine on a slope with
the ROPS folded down (lowered
position).
There is no roll over protection when
the ROPS is in the lowered position.
Lower the ROPS only when absolutely
necessary. Drive slowly and carefully.
Raise the ROPS as soon as clearance
permits. Read and follow slopes
operation instructions and warnings.
Do not wear seat belt when the ROPS
is in the lowered position.
Always pull from the tractor hitch. Do
not attach chains or ropes to the ROPS
for pulling purposes, as the machine
can tip backwards.
Part Number
601635
601635