Heath Zenith Lighting Control Panel 598-1136-04 - Manual (Page 6)

6 598-1136-04
Specifications
Range ...........................................................................Up to 100 feet (30.5 m)
Rated Voltage ....................................................................................... 12 VDC
Battery Backup ....................................................9 VDC (Battery not included)
POSSIBLE CaUSE
1. Circuit breaker or fuse is
turned off. Power supply
not plugged in.
2. Switch on device is turned
off. Power supply is defec-
tive.
1. Backup battery is not in-
stalled.
2. Backup battery is defective.
1. Dip switch settings on re-
ceiver do not match control-
ler.
2. Wrong group is selected.
3. Signals from controller are
being blocked, or transmit-
ter is out of range.
Troubleshooting Guide
SYMPTOM
Controller does
not come on.
C o n t r o l l e r
does not retain
settings in a
power failure.
Controller will
not operate
receiver.
SOLUTION
1. Turn circuit breaker or fuse
on. Plug in power supply.
2. Turned switch on. Try an-
other power supply.
1. Install 9V battery.
2. Replace defective 9V bat-
tery.
1. Check dip switch settings
on receiver.
2. Verify correct group is se-
lected.
3. Check for metal objects that
could block the signal, or
reposition the transmitter.
Press the MODE button to turn a pre-set program(s) ON or OFF. When the
MODE 1 LED is on, all programmed channels for MODE 1 will be activated.
When the MODE 2 LED is on, all programmed channels for MODE 2 will be
activated. To activate both MODE 1 and MODE 2 programs, press the MODE
button until both LED’s are on. To turn off all programmed channels, press the
MODE button until both LED’s are off.
Technical Service
Please call 1-800-858-8501 (English speaking only) for assistance
before returning product to store.
If you experience a problem, follow this guide. You may also want to visit our
Web site at:
www.hzsupport.com. If the problem persists, call* for assistance
at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
HeathCo LLC, P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service
* If contacting Technical Service, please have the following information available:
Model Number, Date of Purchase, and Place of Purchase.
No Service Parts available for these Products