Harbor Freight Tools CENTRAL PNEAMATIC 95386 - Manual (Page 15)

Page 15 For technical questions, please call 1-800-444-3353. SKU 95386
every 6 months or 100 operation
Hours:
Replace Pump oil. ***
changing the oil
Check the oil periodically for clarity.
Replace oil if it appears milky or if
debris is present, or every 6 months,
or 100 hours of runtime, whichever
comes first.
WarnInG: Risk of personal injury hazard.
Allow Air Compressor to cool before
changing the oil.
to drain the oil from the Pump
crankcase:
Place a container under the Oil Drain a.
Plug (24).
Remove the Oil Plug (31) to allow air
b.
flow into the Pump.
Remove the Oil Drain Plug, allowing
c.
the oil to drain into the container.
When the oil is completely drained
d.
from the Pump, replace the Oil Drain
Plug.
Fill the Pump with new compressor
e.
oil to the FULL level on the Oil Sight
Glass.
Replace and tighten the Oil Plug.
f.
Discard the old oil according to local, g.
state and federal regulations.
*** Use Air Compressor Oil only (sold
separately - SKU 95048).
draining moisture from the tank
The Drain Valve (65) is located under
the Air Tank (1). It must be accessed
daily to release all trapped air and
moisture from the Tank. This will
eliminate condensation which can
cause tank corrosion.
note: Do not open the Drain Valve so that
more than four threads are showing.
To empty the air and condensation:
Make sure the Power Button of the a.
compressor is off.
Place a collection pan under the
b.
Drain Valve.
Unthread the Drain Valve by turning
c.
it counterclockwise one full turn
ONLY.
When all the pressure and moisture
d.
is released, close the Drain Valve.
air Filter maintenance
Check the Air Filter (45) weekly
to see if it needs replacement. If
working in dirty environments, you
may need to replace the filter more
often. To replace the Air Filter:
Unthread the Air Filter a.
counterclockwise.
Replace with a new Air Filter.
b.