Heath Zenith DUAL BRITE SL-5318 - Manual (Page 3)

598-1001-01 3
Motion Motion
8 ft.
(2.4 m)
70 ft. 100 ft.
(21 m) (30.5 m)
Boosted
Sensor
240
°
B
O
O
S
T
MAX
MIN
RANGE
ON - TIME DUAL BRITE
TEST 1 5 2 0
MINUTES
OFF 3 6 DUSK TO
HOUR DAWN
TEST AND ADJUSTMENT
❒
Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1 1 /
2
minute warm up period
before it will detect motion. When first turned
on, wait 1
1 /
2
minutes.
Bottom of Sensor
Avoid aiming the control at:
• Objects that change temperature rapidly, such as
heating vents and air conditioners. These heat
sources could cause false triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light-colored objects reflecting light
may trigger the shut-off feature. Do not point other
lights at the sensor.
❒ Turn the RANGE control to the mid position, Dual
Brite™ to OFF and the ON-TIME control to the
TEST position.
Maximum
Maximum Range Coverage Angle
The detector is less sensitive to motion directly towards it.
Least Sensitive Most Sensitive
SPECIFICATIONS
Horizontal Range . . . Up to 70 ft. (21 m); 100 ft.
(30.5 m) with Range Boost.
[varies with surrounding
temperature]
Sensing Angle . . . . . . Up to 240
°
Electrical Load . . . . . . Up to 300 Watt Maximum In-
candescent [Up to 150 Watt
Maximum each lamp holder.]
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO, and MANUAL
MODE
Time Delay . . . . . . . . 1 , 5, 20 minutes
Dual Brite™ Timer . . . 3, 6 hours, Dusk-to-Dawn
Warning - Risk of fire. Do not aim the lamps at a
combustible surface within 3 ft. (1 m).
❒ Loosen the clamp screw in
the sensor ball joint and gen-
tly rotate the sensor.
❒
Walk through the coverage
area noting where you are
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cov-
erage area. Keep the sen-
sor at least 1" (2.5 cm) away
from the lamps.
❒ Adjust the RANGE as
needed. RANGE set too high
may increase false triggering.
❒ Secure the sensor head by
tightening the clamp screw.
Do not overtighten the screw.
❒ Set the amount of TIME you
want the lights to stay on after
motion is detected (1, 5, or 20 minutes).
❒
Set the DUAL BRITE™ switch to the amount of
time after dusk you want the lights on at low level
(Off, 3, 6 Hrs., Dusk-to-Dawn).
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
DESA Specialty Products™ reserves the right to dis-
continue products and to change specifications at any
time without incurring any obligation to incorporate new
features in products previously sold.