HONDA 08B26-S5T-1000-91 - Manual (Page 11)

© 2004 American Honda Motor Co., Inc - All Rights Reserved. AII 27936 (0408)
11 of 14
Routing the Bus Cable
48. From the back of the left rear side trim panel, route
the bus cable as shown. Secure the bus cable to
the fuel fill door opener cable with two wire ties in
the areas shown. Do not secure the bus cable to
the clear washer tube.
49. Secure the bus cable to the body panel with one
cushion tape in the area shown. Clean the area
where the cushion tape will attach with isopropyl
alcohol.
50. Route the bus cable from the side panel to the
center of the floor panel along the floor cross
member as shown.
BUS CABLE
CUSHION TAPE
FLOOR CROSS
MEMBER
FLOOR
CARPET
(Turn over.)
Route the BUS
cable from the
center of the floor
to the front.
FLOOR
PANEL
CENTER PANEL
OPENING
VEHICLE HARNESS
BUS CABLE
51. Secure the bus cable to the floor panel with two
cushion tapes in the areas shown. Clean the areas
where the cushion tapes will attach with isopropyl
alcohol.
52. Continue routing the bus cable through the center of
the floor panel to the center panel opening.
BUS
CABLE BUS
CABLE
Do not secure the
bus cable to the
clear washer tube. WIRE TIE
VEHICLE
HARNESS
CUSHION
TAPE
WIRE TIE
FUEL FILL
DOOR
OPENER
CABLE