Hisense Group PDP5010EU - Manual (Page 11)

Press <Display> button on the remote control to display the present channel number, but it will also disappear 3
seconds after your pressing.
Display channel number
Press the <Still> button on the remote control to snapshot the present picture.
Press this button again to return to normal watching.
Use <Still> button
Press the <Recall> button on the remote control repeatedly to alternate between the present channel and the
previous channel.
Use <Recall> button
You can select the picture mode fromamong three preset modes and one user-set
mode.
Press the < P.mode> button on the remote control repeatedly to select the desired
picture mode.
Select picture modes
You can select the sound mode from among three preset modes and one user-set
mode.
Press the <S.mode> button on the remote control repeatedly to select the desired
sound mode.
Select sound modes
Adjust Volume
When menu is not displayed on the screen, Press the <VOL->or<VOL+>button on the remote control to adjust the
volume level. Push the <Volume up> or <Volume down> Key to adjust the volume level also.
To select a channel : Press the channel numbers in series to select channel directly.
Press the button 1, and 1_ _ will display on the top right corner of the screen,
then press the button 2, 12_ will display, press the button zero, you can enjoy the program of channel 120.
For example, to seclect channel 120,
Select channels by numbers
Bright
Normal
Soft
User
Speech
Normal
Music
User
- 9 -
NOTE:1) When you changing the channel, the sound state, colour system state& sound system state graphics can be
displayed below the channel number. There are 3 sound states in this TV. If the sound is mono, the graphics
is , If the sound is stereo, the graphics is . If the sound is NICAM dual I/II, the graphics is . But the
colour system state & sound system state is you preset the state
When you changing the channel, the sound of current channel will be firstly changed to stereo or NICAM dual
according to the sound state of current channel. You can press the
I/II button on the remote control to change
current sound type.