Harbor Freight Tools 67708 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. SKU 67708
assembly/mounting
Figure 2
Bolt (64)
Bolt (64)
Hex
Nuts
(65)
Handle (72)
Bolts (71)
Bolts (71)
Tank (70)
Wheel (63)
Wheel (63)
1. Attach the Wheels to the Tank, using the
Bolts and Hex Nuts.
Slide the Handle into the two slots on the
2.
top of the Tank and secure in place with
four Bolts.
Figure 3
Air Filter
(6)
Cylinder Head (7)
3. Thread the Air Filter onto the side of the
Cylinder Head.
Break in the new Air Compressor as
4.
follows:
Make sure the Power Switch is OFF a.
and the unit is unplugged. Insert a
male coupler (sold separately) into the
female Quick Coupler and fully open all
regulators and valves.
Plug in the Power Cord.
b.
Turn the Power Switch ON. c.
Let the unit run for 30 minutes. Air will d.
expel freely through the Coupler.
Turn the Power Switch OFF.
e.
Unplug the Power Cord and remove the f.
male coupler.
Connect a regulator valve, an inline shut 5.
off valve and a 1/4” NPT air hose to the
Quick Coupler (all sold separately). The
air hose must be long enough to reach
the work area with enough extra length
to allow free movement while working.
note: an in-line shutoff ball valve is an
important safety device because it
controls the air supply even if the air
hose is ruptured. the shutoff valve
should be a ball valve because it can
be closed quickly.
Quick
coupler
Sample air line Setup
regulator with
Pressure Gauge
Quick
coupler air Hose
on reel
Shut
off
Valve
Filter oiler
coupler
Plug
tool
air
compressor
coupler
Plug
6. Depending on the tool which you will
be using with this compressor, you
may need to incorporate additional
components, such as an in-line oiler,
a filter, or a dryer (all sold separately).