HONDA Honda Engine GXV340 - Manual (Page 11)

HELPFUL TIPS & SUGGESTIONS
STORING YOUR ENGINE
Storage Preparation
Cleaning
Fuel
SPARK ARRESTER (applicable types)
Spark Arrester Removal
Spark Arrester Cleaning & Inspection
ENGLISH
MUFFLER MUFFLER PROTECTOR
SPARK ARRESTER
8 mm BOLT
GASKET
IDENTIFICATION PLATE
SPARK ARRESTER
SCREEN
5 mm SCREW (3)
8 mm NUT (2)
11
Proper storage preparation is essential for keeping your engine
trouble-free and looking good. The following steps will help to
keep rust and corrosion from impairing your engine’s function and
appearance, and will make the engine easier to start when you use
it again.
If the engine has been running, allow it to cool for at least half an
hour before cleaning. Clean all exterior surfaces, touch up any
damaged paint, and coat other areas that may rust with a light film
of oil.
Using a garden hose or pressure washing equipment can force
water into the air cleaner or muffler opening. Water in the air
cleaner will soak the air filter, and water that passes through the
air filter or muffler can enter the cylinder, causing damage.
Gasoline will oxidize and deteriorate in storage. Deteriorated
gasoline will cause hard starting, and it leaves gum deposits that
clog the fuel system. If the gasoline in your engine deteriorates
during storage, you may need to have the carburetor, and other
fuel system components, serviced or replaced.
The length of time that gasoline can be left in your fuel tank and
carburetor without causing functional problems will vary with
such factors as gasoline blend, your storage temperatures, and
whether the fuel tank is partially or completely filled. The air in a
partially filled fuel tank promotes fuel deterioration. Very warm
storage temperatures accelerate fuel deterioration. Fuel problems
may occur within a few months, or even less if the gasoline was
not fresh when you filled the fuel tank.
Fuel system damage or engine performance problems resulting
from neglected storage preparation are not covered under the
Distributor’s Limited Warranty.
You can extend fuel storage life by adding a gasoline stabilizer
that is formulated for that purpose, or you can avoid fuel
deterioration problems by draining the fuel tank and carburetor.
The spark arrester may be standard or an optional part, depending
on the engine type. In some areas, it is illegal to operate an engine
without a spark arrester. Check local laws and regulations. A spark
arrester is available from authorized Honda servicing dealers.
The spark arrester must be serviced every 100 hours to keep it
functioning as designed.
If the engine has been running, the muffler will be hot. Allow it to
cool before servicing the spark arrester.
Remove the three 5 mm screws from the muffler protector.
Remove the 8 mm bolt and the two 8 mm nuts, and remove the
muffler protector, identification plate, muffler and gasket from
the cylinder.
Use a brush to remove carbon
deposits from the spark arrester
screen. Be careful not to damage
the screen. Replace the spark
arrester if it has breaks or holes.
Install the gasket, spark arrester, muffler, identification plate,
and muffler protector in reverse order of removal.
Remove the spark arrester from the muffler (take care not to
damage the wire mesh).
1.
2.
3.
1.
2.
05/04/18 14:40:50 32Z5N600_011