Hafler SR2800CE - Manual (Page 20)

– 18 –
1. Connect signal from source to both CH A and CH B
inputs.
2. Move Biamp/Stereo switch to Stereo input mode.
3. Move Stereo/Mono switch to Stereo mode.
4. Select desired speaker load (8
Ω/4Ω/2Ω) for each
channel – CH A & CH B loads do not need to match.
5. Connect appropriate speaker load 8 Ω/4Ω/2Ω to 5-way
binding posts. CE units: Connect as shown above for
Dual SPEAKONs or Single 4-Wire SPEAKON.
6. Adjust CH A & CH B level controls independently.
1. Connect signal from source to CH B input.
2. Move Biamp/Stereo switch to BIAMP input mode.
3. Move Stereo/Mono switch to Stereo mode.
4. Select desired speaker load (8
Ω/4Ω/2Ω) for each
channel — CH A and CH B loads do not need to match.
5. Connect appropriate speaker load 8 Ω/4Ω/2Ω to 5-way
binding posts. CE units: Connect as shown above for
Dual SPEAKONs or Single 4-Wire SPEAKON.
6. Adjust CH A & CH B level controls independently.
Power
70V 4 Ω
Load
2 Ω 100V 8 Ω
70V 4 Ω 2Ω 100V 8 Ω
BIAMP STEREO CH A IN
—
+
300W 2 Ω – 8Ω
Mono,70V,100V
CH B IN
CH A OUT
CH B OUT
+
— 300W 2 Ω – 8Ω
—
+
600W
For 70V, 100V, or Mono
• Use CH B input
• Load across RED
terminals
• Set load switches to one
half load impedance
A Division of
Rockford Corp.
Tempe, AZ 85281
Made in the U.S.A.
S R 2 3 0 0
300 W Stereo, 2 Ω – 8Ω
600W Mono, 70V,100V
(Mono) 250W 100V-120V~ 50-60Hz 250V T7A
Chassis Float
Audio GND
3
2 1 +
–
+ –
Attention: Utiliser un fusible de rechange de même type.
CAUTION: For continued protection from risk of fire, replace only with same type and rating of fuse.
4 Ω– 16Ω
Wiring Diagrams
Power
70V 4 Ω
Load
2 Ω 100V 8 Ω
70V 4 Ω 2Ω 100V 8 Ω
BIAMP STEREO CH A IN
—
+
300W 2 Ω – 8Ω
Mono,70V,100V
CH B IN
CH A OUT
CH B OUT
+
— 300W 2 Ω – 8Ω
—
+
600W
For 70V, 100V, or Mono
• Use CH B input
• Load across RED
terminals
• Set load switches to one
half load impedance
A Division of
Rockford Corp.
Tempe, AZ 85281
Made in the U.S.A.
S R 2 3 0 0
300 W Stereo, 2 Ω – 8Ω
600W Mono, 70V,100V
(Mono) 250W 100V-120V~ 50-60Hz 250V T7A
Chassis Float
Audio GND
3
2 1 +
–
+ –
Attention: Utiliser un fusible de rechange de même type.
CAUTION: For continued protection from risk of fire, replace only with same type and rating of fuse.
4 Ω– 16Ω
STEREO MODE (SR2300/SR2800)
BIAMP MODE (SR2300/SR2800)
CE SPEAKON
Connector
Wiring
CE SPEAKON
Connector
Wiring