Harbor Freight Tools 94057 - Manual (Page 7)

Page 7 For technical questions, please call 1-800-444-3353. Item 60333 94057
2-Wheel Bike Loading
1. Do not attempt to load any dirt bike
or other 2-wheel motor bike alone.
Have a qualified adult assist.
2. Line up the 2-wheel bike
with one of the Ramp.
3. With one person pushing the bike
slowly up the Ramp, a helper should be
in the bed of the hauling vehicle both
to guide and to apply the brake if it is
necessary to stop the bike while it is
on the Ramp. Have one person with a
hand on the bike hand brake for safety.
4. Once the person inside the truck bed
has hold of the handle bars, apply
the brake and steady the bike while
the other person moves behind the
bike (but off to one side) and pushes
it all the way into the truck bed.
NOTE: While most dirt bikes are light
enough to safely load with two people, a third
person can make the job easier and safer.
5. Once the bike is safely loaded, secure it
with four tie down straps (not included),
one on each side of the front, and one
on each side at the rear of the bike.
2-Wheel Bike Unloading
1. Position the Ramp against the
truck tailgate behind the rear
tire of the bike and attach the
Safety Chain to the truck bed.
2. Remove the tie-down
straps (not included).
3. Slowly and carefully while using an
assistant, push the bike backwards until
the back tire is at the top of the Ramp.
With one person on the ground behind
and to the side of the Ramp, slowly
push the bike onto the Ramp. Someone
must always hold the hand brake.
4. Slowly work the bike down the
Ramp and onto the ground.