Hand Held Products Hand Held Computer Dolphin 7450 - Manual (Page 56)

6 - 6
USB HomeBase
There is a 5V DC power supply connector and a USB connector:
Power supply connector Use this connector to attach a power supply to the HomeBase. The power supply provides 5V DC
input for communications and battery charging.
USB Communications Port Use a USB full-speed detachable cable to connect this downstream device port to an upstream
USB Host or Hub. The USB HomeBase is USB 1.3 compliant.
Bottom Panel of HomeBase/IntelliBase/IntelliBase+
A Baud Rate switch used to select the communication baud rate is located on the bottom of the HomeBase, IntelliBase and
IntelliBase+. The Baud Rate Switch on the HomeBase is a three-position switch; four-position on the IntelliBase and IntelliBase+.
Switch position and the corresponding baud rates are shown in the charts below.
The USB HomeBase does not require a baud rate switch.
Rear View of Dolphin USB HomeBase
Power Supply
Connector
USB Connector