Hitachi WirelessIP 5000 - Manual (Page 88)

- 6-9 -
Chapter 6
Other settings
Alarm
Setting the alarm function
1 To change the alarm function settings, from the setting menu,
Select "3. Alarm" using the keys of the key,
then press the key.
2 Up to 3 alarm settings can be registered..
Select "1. Alarm 1", "2. Alarm 2", or "3. Alarm 3" using the keys of the
key,
then press the key.
3 Alarm setting information is displayed.
・ Setup
・ Time
・ Ring
・ Repeat
To change a setting, Using the key, select “Edit.”
For the setup, select "On" or "Off".
If you select "Off", the setting can be saved, but the alarm does not operate.
Enter the alarm time.
For "Ring", select from "Bell 1" through "Bell 5", Vib.", or "Silent".
For frequency, select from "Once", "Everyday", "Mon-Fri", or "Mon-Sat".
Finally, save with the key.