Hotpoint RGB747GER - Manual (Page 42)

INSTALLATION INSTRUCTIONS
(continued)
HOW TO CONVERT THE RANGE FOR USE
WITH 1P GAS OR NATURAL GAS
(continued)
❑
CONVERTING SURFACE BURNERS
Burner Cap
1. Remove grates, burner caps and burner heads.
2. Remove burner bases by unscrewing the 3
small screws in each base. Lift
burner
straight out.
DO NOT disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
a 7mm or 5/16” wrench (depending on the size of
your spuds). Apply a 3/4” wrench to the hex on
the gas inlet tube as a back-up when removing
spud to prevent the aluminum tube from twisting.
4. Install orifice spuds according to one of the
following diagrams (see
❑
or
❑
), for LP gas
or natural gas, depending on which you are
converting to.
❑
Orifice Spuds for
LP orifice spuds are in a small plastic bag packed
with this Use and Care book. LP orifice spuds
have a 2-digit number and the Letter “L” on
one side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
❑
Orifice Spuds for Converting to Gas:
Natural gas orifice spuds have a 3-digit number
on one side. Each orifice spud will also have 1, 2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
Front of Range
42
—