Harman-Kardon AVR 700 - Manual (Page 13)

AVR 700/AVR 70/AVR 70C
13
Making Connections, continued
Audio recorders
connect an analog audio recorder’s inputs to the AVr’s analog audio tape out connectors.
you can record any analog audio input signal except for the tape 1 input.
Stereo Audio cable
(not supplied) to Stereo Analog
record Inputs
Analog recording device
AVr Analog Audio
recorder connectors
Video recorders
connect an analog video recorder’s video input connector to the AVr’s Video 1 out
composite Video connector, and its audio input connectors to the AVr’s Video 1 out
Analog Audio connectors. you can record the Video 2 or Video 3 composite video input
signals.
Analog Audio/Video
cable (not supplied)
to Analog Audio/
Video record Inputs
Analog Video
recording device
AVr Analog
Audio connectors
AVr composite
Video connectors
Connect the Radio Antennas
• Connect the supplied FM antenna to the AVR’s FM 75Ω radio Antenna connector. for
the best reception, extend the fm antenna as far as possible.
• Bend and fold the base of the supplied AM antenna as shown and connect the
antenna wires to the AVr’s Am and gnd connectors. rotate the antenna as necessary
to minimize background noise.
AVr Antenna
connectors
fm Antenna (supplied)
Am Antenna
(supplied)
bend and fold base
Connect to AC Power
connect the Ac power cord to the AVr’s Ac Input connector and then to a working Ac
power outlet.
AVr Ac
Input connector
Ac power
outlet
power cord
(supplied)
Install the Batteries in the Remote Control
remove the remote control’s battery cover, insert the three supplied AAA batteries as
shown in the illustration, and replace the battery cover.
note: remove the protective plastic from the AVr’s front panel to keep it from reducing
the remote control’s effectiveness.