Heath Zenith 6280 - Manual (Page 4)

-4- 595-5506-09
ery Battery
ery Battery
B Battery
Ch im
e
V
o
lu
m e
12
345
6
7
8
12
345
6
7
8
Push Button Battery Replacement
Install an alkaline type A23 12 Volt bat-
tery. See diagram inside push button for
correct battery orientation.
* Code Settings 1-7
Must Match Both
Push Button and
Chime
Inside Push
Button
Inside Chime
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Tune
Setting
Tune Setting
(Not used on
all models)
Tune Settings
Your Heath ® /Zenith wireless chime has different selectable tunes: Ding (one
note), Ding-Dong (two note), or Westminster (eight note) (Available on se-
lected Heath
® /Zenith chimes). The factory setting is for the Ding-Dong tune
(or Westminster, when available). This tune can be changed by following the
instructions below.
•
Ding (one note tune)
Push Button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune) (Available on selected Heath ® /Zenith chimes)
Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. You may
purchase any Heath
® /Zenith wireless push button for a second entrance. We
recommend the back door use the Ding tune and the front door use the
Ding-Dong tune (or Westminster tune, available on selected Heath
® /Zenith
chimes). Models that include two push buttons will come factory set for front
and back doors. Decals on the rear of the push button will indicate its setting.