Husqvarna 968999102 / W3612A - Manual (Page 16)

16
Adjustment Instructions for:
MODELS
/
I.D.
:
968999105
/
WH3614A
968999111
/
WH3615A
968999106
/
WH4817A
CUTTING HEIGHT
1. Before changing cutting heights make sure the blades are off, key switch is off, and remove
spark plug wire or wires.
2. Cutting height ranges from 1 1/2” to 5” in 1/4” increments.
3. Cutting height can be changed three ways. Move one “C” spacer on the front casters,
change the blade spacers, or move the wheel motor assemblies.
4. a. To change heights on the rear deck loosen, do not remove, the top two carriage bolts on
both sides. (see fig. 1a)
b. Place a jack under the center of the rear deck remove the bottom two nuts on both sides.
Then remove the bottom two bolts both sides. (May have to raise the jack slightly to remove
bolts.)(see fig. 1b)
c. With the jack raise or lower the rear deck to the desired position using the chart, on page
7, to ensure proper height.
Hydro Intermediate Walk Behind