Husqvarna 968999102 / W3612A - Manual (Page 6)

6
SETUP AND ADJUSTMENTS FOR SETUP AND ADJUSTMENTS FOR SETUP AND ADJUSTMENTS FOR SETUP AND ADJUSTMENTS FOR SETUP AND ADJUSTMENTS FOR
HUSQVARNA 32", 36" AND 48" COMMERCIAL MOWERS HUSQVARNA 32", 36" AND 48" COMMERCIAL MOWERS HUSQVARNA 32", 36" AND 48" COMMERCIAL MOWERS HUSQVARNA 32", 36" AND 48" COMMERCIAL MOWERS HUSQVARNA 32", 36" AND 48" COMMERCIAL MOWERS
BLADE ENGAGEMENT LEVER BLADE ENGAGEMENT LEVER BLADE ENGAGEMENT LEVER BLADE ENGAGEMENT LEVER BLADE ENGAGEMENT LEVER
The blade engagement lever needs to be adjusted so
the lever does not come in contact with control panel
when the lever is in the off position.
To adjust, remove the clevis pin from the yoke and
adjust by turning the yoke. The clevis pin connects the
blade engagement lever to the yoke, and the yoke is
connected to the blade engagement rod that runs to the
bellcrank on the rear deck.
TRANSMISSION DRIVE BELT TRANSMISSION DRIVE BELT TRANSMISSION DRIVE BELT TRANSMISSION DRIVE BELT TRANSMISSION DRIVE BELT
To increase the tension of the transmission belt, loosen
the nut on the underside of the transmission idler pulley
located under the rear deck, slide the idler assembly
inward to increase tension and tighten the nut to secure.
See figures 4 & 5.
BELT GUIDES BELT GUIDES BELT GUIDES BELT GUIDES BELT GUIDES
Belt guides under rear deck are adjusted as shown in
figures 4 and 5
NOTE: The blades should come to a stop from NOTE: The blades should come to a stop from NOTE: The blades should come to a stop from NOTE: The blades should come to a stop from NOTE: The blades should come to a stop from
maximum speed within 7 seconds after
maximum speed within 7 seconds after maximum speed within 7 seconds after maximum speed within 7 seconds after maximum speed within 7 seconds after
disengaging.
disengaging. disengaging. disengaging. disengaging.
TRANSMISSION IDLER PULLEY
32" & 36" MODEL 32" & 36" MODEL 32" & 36" MODEL 32" & 36" MODEL 32" & 36" MODEL 48" MODEL 48" MODEL 48" MODEL 48" MODEL 48" MODEL
Figure 4 Figure 5
TRANSMISSION IDLER PULLEY
TRANSMISSION BELT
1/4" CLEARANCE
1/2"
ENGINE PULLEY
1/8" CLEARANCE
1/8" CLEARANCE
TRANSMISSION BELT
1/8" CLEARANCE
1/2"
ENGINE PULLEY
102036
103463
103462
102036 103462
103462