Hitachi VT-DX815A - Manual (Page 22)

DSS® BOX WITHOUT DIGITAL INTERFACE HOOKUP – RF
HOOKUP [E]
22
DSS® BOX WITHOUT DIGITAL INTERFACE HOOKUP – RF HOOKUP [E]
WITH THIS HOOKUP
YOU CAN......
• WATCH AVAILABLE TV OR DSS® CHANNELS
• RECORD AND WATCH THE SAME CHANNEL
• RECORD ONE CHANNEL AND WATCH ANOTHER
YOU CAN'T......
• RECORD A CHANNEL OTHER THAN DSS® AND WATCH A DSS®
CHANNEL
Hookup E Illustration pic
Note: Your VCR cannot receive RF signals from the antenna or cable through
the DSS® box. Connect the antenna or cable cord to the IN FROM ANT jack of
the VCR, not to the RF IN/OUT jacks of the DSS® box.
TABLE E
FUNCTION
CHANNEL SELECTION
VCR indicator
(Press the VCR/TV
mode select button to
turn the VCR indicator
on or off)
TV VCR DSS® BOX
Select and Watch
Channels using TV Select Channel to
Watch OFF
(TV mode)
Select and Watch
Channels using VCR 3 or 4 Select Channel to
Watch ON
(VCR mode)
Record and Watch the
Same Channel 3 or 4 Select Channel to
Record ON
(VCR mode)
Record One Channel
Watch Another Select Channel to
Watch Select Channel to
Record OFF
(TV mode)
Record and Watch the
Same DSS® Channel 3 or 4 Select L1 Select Channel to
Watch/Record ON
(VCR mode)
Watch a Channel other
than DSS® and Record a
DSS® Channel Select Channel to
Watch Select L1 Select Channel to
Record OFF
(TV mode)
Watch Playback of a Tape 3 or 4 ON
(VCR mode)
Switch the RF Channel
When the VCR is on, its video signal can come into your TV on either
channel 3 or channel 4. You need to select the appropriate channel.
• Turn on the power of both the TV and the VCR. Press the ANT. OUT
button on front of the VCR. Pressing the button alternates between RFCH
03 (channel 3) and RFCH 04 (channel 4) in the VCR's display.
Display the channel which is not used by a commercial channel in your
area.