Caution, Warning, B. lighting appliance – Heat & Glo Fireplace GRAND-XTS User Manual

Page 29

Advertising
background image

29

Heat & Glo • Supreme-XTS, Grand-XTS • 349-901 Rev. i • 12/09

B. Lighting Appliance

Standing Pilot Ignition

1. Turn off all electric power to the appliance if

service is to be performed.

2. Open control access panel.

3. Move switch to “OFF” position.

4. Push in gas control knob slightly and turn clock-

wise

to OFF”. Do not force.

5.

Close control access panel.

5. Turn knob on gas control counter clockwise

to “PILOT”.

6. Push in control knob all the way and hold in. Im-

mediately depress red or black piezo button. It may
require several depressions of the red or black
piezo button until PILOT lights. If PILOT light does
not light after 10 seconds, return to step 3. Continue to
hold the control knob in for about one minute after the
pilot is lit. Release knob and it will pop back out. Pilot
should remain lit. If it goes out, repeat steps 3 through 6.

If knob does not pop up when released, stop and im-

mediately call your service technician or gas supplier.

If the pilot will not stay lit after several tries, turn

the gas control knob to “OFF” and call your service
technician or gas supplier.

7. Turn gas control knob counterclockwise to

“ON”.

8. To light Burner, fl ip the on/off switch to the “ON”

position, and close access grille.

9. Turn on all electric power to the appliance.

1. Turn off all electric power to the appliance.

2. Push in gas control knob

slightly and turn clockwise

to “OFF”.

NOTE: Knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.

3.

Wait fi ve (5) minutes to clear out any gas.

Then smell for gas, including near the fl oor. If you
smell gas, STOP! Follow “B” in the Safety Informa-
tion located on the left side of this label. If you don’t
smell gas, go to next step.

4. Find the pilot. The pilot is inside

combustion chamber next to the
main burner.

LIGHTING

INSTRUCTIONS

TO TURN OFF

GAS TO APPLIANCE

FOR YOUR SAFETY

READ BEFORE LIGHTING

DO NOT CONNECT 110 VAC TO
THE CONTROL VALVE.

Improper installation, adjustment, al-
teration, service or maintenance can
cause injury or property damage. Re-
fer to the owner’s information manual
provided with this appliance.

This appliance needs fresh air for
safe operation and must be installed
so there are provisions for adequate
combustion and ventilation air.

If not installed, operated, and main-
tained in accordance with the man-
ufacturer’s instructions, this product
could expose you to substances in fuel
or fuel combustion which are known to
the State of California to cause can-
cer, birth defects, or other reproduc-
tive harm.

Keep burner and control compartment
clean. See installation and operating
instructions accompanying appliance.

CAUTION:

Hot while in operation. Do not touch.
Keep children, clothing, furniture, gaso-
line and other liquids having fl ammable
vapors away.

Do not operate the appliance with
panel(s) removed, cracked or broken.
Replacement of the panel(s) should be
done by a licensed or qualifi ed service
person.

NOT FOR USE

WITH SOLID FUEL

For use with natural gas and propane.
A conversion kit, as supplied by the
manufacturer, shall be used to convert
this appliance to the alternate fuel.

Also Certifi ed for Installation in a
Bedroom or a Bedsitting Room.

For assistance or additional informa-
tion, consult a qualifi ed installer, ser-
vice agency or the gas supplier.

WARNING:

464-903G

A. This appliance has a pilot which

must be lighted by hand. When
lighting the pilot, follow these
instructions exactly.

B. BEFORE LIGHTING, smell all

around the appliance area for gas.
Be sure to smell next to the fl oor
because some gas is heavier than
air and will settle on the fl oor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch;

do not use any phone in your
building.

• Immediately call your gas supplier

from a neighbor’s phone. Follow
the gas supplier’s instructions.

• If you cannot reach your gas sup-

plier, call the fi re department.

C. Use only your hand to push in or

turn the gas control knob. Never
use tools. If the knob will not push
in or turn by hand, don’t try to
repair it, call a qualifi ed service
technician. Force or attempted
repair may result in a fi re or explo-
sion.

D. Do not use this appliance if any

part has been under water. Im-
mediately call a qualifi ed service
technician to inspect the appliance
and to replace any part of the
control system and any gas control
which has been under water.

For additional information on operating your

Hearth & Home Technologies fi replace, please refer to www.fi replaces.com.

WARNING: If you do not follow these instructions
exactly, a fi re or explosion may result causing property
damage, personal injury or loss of life.

Advertising
This manual is related to the following products: