HoMedics OCTS-200 - Manual (Page 4)

6 7
3. Attach the seat base mechanism to the underside of the seat
cushion using the included Allen wrench and 4 of the screws.
Make sure the arrow on the seat base mechanism is pointing
toward the front edge of the seat cushion (label on seat cushion).
4. Place the seat cushion on top of the pneumatic cylinder. Make sure
the cylinder is positioned properly by sitting on the seat cushion.
5. Attach the armrests (labeled as R and L for right and left sides) onto
the seat cushion using the included Allen wrench and 4 of the screws
(2 on each side). DO NOT TIGHTEN THE SCREWS COMPLETELY.
6. Connect remote arm wires to chair wires and feed into the opening
in the side of the chair.
Figure 4
Figure 5
Figure 6
Figure 7A Figure 7B