Operating instructions – Harbor Freight Tools Drill Master 3733 User Manual
Page 14
Page 14
SKU 3733
For technical questions, please call 1-800-444-3353.
Table (adjacent to Blade slot) and
tighten.
Reinstall the Table and secure it in
7.
place with the Screw (16).
OpERATIng InSTRucTIOnS
Read the EnTIRE IMpORTAnT
SAFETY InFORMATIOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
Tool Set up
TO pREVEnT
SERIOuS InjuRY
FROM AccIdEnTAL
OpERATIOn: Turn the power
Switch of the tool to its “OFF”
position and unplug the tool
from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
1.
Place Tile Saw on a flat and level
surface. use carpenter’s level (not
supplied) to make any necessary
leveling adjustments by inserting
shims (not included). Slide Bench
Stops (22) over plastic stands to se-
cure Tile Saw against table or bench
edge.
2.
use clamp (not included) to secure
and support smaller work pieces to
the built-in fence. Holding work by
hand or against your body is unstable
and may lead to loss of control.
3.
do not force tool. use the cor-
rect tool for your application. The
correct tool will do the job better and
safer at rate for which it is designed.
4.
do not use the power tool if the
power Switch does not turn it
on or off. Any tool that cannot be
controlled with the Power Switch is
dangerous and must be replaced.
5.
disconnect power cord plug from
the power source before making
any adjustments, changing acces-
sories, or storing the tool. Such
preventive safety measures reduce
risk of starting the tool accidentally.
6.
Store idle tools out of reach of chil-
dren and other untrained persons.
Tools are dangerous in the hands of
untrained users.
7.
Maintain tools with care. Keep
tools clean. Properly maintained
tools are easier to control. Do not
use a damaged tool. Tag damaged
tools “Do not use” until repaired.
8.
check for misalignment or binding
of moving parts, breakage of parts,
and any other condition that may
affect the tool’s operation. If dam-
aged, have the tool serviced before
using. Many accidents are caused
by poorly maintained tools.
9.
use only accessories that are
recommended by the manufacturer
for your tool. Accessories suitable
for one tool may become hazardous
when used on another tool.
Work piece and Work Area Set up
designate a work area that is clean
1.
and well lit. The work area must not
allow access by children or pets to
prevent injury and distraction.