Harbor Freight Tools Drill Master 3733 User Manual
Page 15
Page 15
SKU 3733
For technical questions, please call 1-800-444-3353.
Route the power cord along a safe
2.
route to reach the work area with-
out creating a tripping hazard or
exposing the power cord to pos-
sible damage. The power cord must
reach the work area with enough
extra length to allow free movement
while working.
Secure loose work pieces using
3.
clamps (not included) to prevent
movement while working.
general Operating Instructions
To Make Straight Cuts:
Remove the Screw. Then remove
1.
the Table from the Tile Saw unit.
Fill the Body (19) with water. Be sure
2.
to use cold, clean water.
WARNING!
3.
Make sure water level
is high enough to cover lower edge
of Tile Saw Blade (sold separately,
not included), but not above max
water level as indicated by arrow.
The Blade’s edge must be sub-
merged in water at all times. See
Figure 4, below.
Reinstall Table and secure it in place
4.
with the Screw (16).
Adjust the Rip Fence (7) to the width
5.
of cut desired. To do so, lift up on
each Lever (9) located at each end of
the Rip Fence. Slide the Rip Fence
to the right or left until the desired
width of cut is obtained. Then, lock
the Rip Fence in place by pressing
down on each Lever.
cAuTIOn!
Keep fingers clear of Levers.
Plug the Power Cord (11) into a
6.
grounded, 120 Volt electrical outlet.
Turn the Power Switch (4) to its “ON”
7.
position, and allow the Blade to spin
up to full speed.
nOTE:
8.
Make sure the Blade is pick-
ing up water from the Body of the
unit. If not, turn the Power Switch
to its “OFF” position, and unplug the
Power Cord from its electrical outlet.
Then, check the water level.
Once the proper water level is ac-
9.
quired, plug the Power Cord into its
electrical outlet and turn the Power
Switch to its “ON” position.
Place the workpiece to be cut against
10.
the Rip Fence (7), and then slowly
feed the workpiece into the spinning
Blade.
When finished making the cut, turn
11.
the Power Switch (4) to its “OFF”
position and unplug the Power Cord
(11) from its electrical outlet.
To Make Beveled Cuts:
Remove the Screw. Then, remove
1.
the Table from the Tile Saw unit.
Fill With Water As Indicated By Arrow
DO NOT OVERFILL
FIguRE 4