HP 2570 User Manual
Page 106
1 Power connection 1
2 Power connection 2
3 Grounded power outlet
I connected the USB cable, but I am having problems using the HP All-in-One
with my computer
Solution
You must first install the software that came with your HP All-in-One
before connecting the USB cable. During installation, do not plug in the USB
cable until prompted by the onscreen instructions. Connecting the USB cable
before prompted can cause errors. If you connected the USB cable before you
installed the software, see Troubleshooting common setup issues under
Once you have installed the software, connecting your computer to your HP All-in-
One with a USB cable is straightforward. Simply plug one end of the USB cable
into the back of your computer and the other into the back of the HP All-in-One.
You can connect to any USB port on the back of your computer.
Note
Make sure you connected the USB cable to the correct port on the
back of your HP All-in-One.
User Guide
103
Troubleshooting