Bluetooth settings – HP 2570 User Manual

Page 42

Advertising
background image

Parameter

Description

Configuration
Source

The protocol used to assign the IP address to the HP All-in-One:

AutoIP: The installation software automatically determines
the configuration parameters.

DHCP: The configuration parameters are supplied by a
dynamic host configuration protocol (DHCP) server on the
network. On small networks, this could be a router.

Manual: The configuration parameters are set manually, such
as a static IP address.

Not Specified: The mode used when the HP All-in-One is
initializing.

DNS server

The IP address of the domain name service (DNS) for the
network. When you use the web or send an e-mail message, you
use a domain name to do it. For example, the URL http://
www.hp.com contains the domain name hp.com. The DNS on the
Internet translates the domain name into an IP address. Devices
use the IP addresses to refer to one another.

IP Address: The IP address of the domain name server.

Not Specified: The IP address is not specified, or the device
is initializing.

Note

Check to see if a DNS IP address appears on the network

configuration page. If no address is shown, obtain the DNS IP
address from your Internet service provider (ISP).

Link
Configuration

The speed at which data is transmitted over a network. Speeds
include 10TX-Full, 10TX-Half, 100TX-Full, and 100TX-Half.
When set to None, networking is disabled.

Total Packets
transmitted

The number of packets transmitted by the HP All-in-One without
error since it has been turned on. The counter clears after the
HP All-in-One is turned off. When a message is transmitted over a
packet-switching network, it is broken up into packets. Each
packet contains the destination address as well as the data.

Total Packets
received

The number of packets received by the HP All-in-One without
error since it has been turned on. The counter clears after the
HP All-in-One is turned off.

Bluetooth settings
The following table describes the Bluetooth settings shown on the network
configuration page.

Parameter

Description

Device Address The hardware address of the Bluetooth device.

(continued)

User Guide

39

Network setup

Advertising
This manual is related to the following products: