Harbor Freight Tools ELECTRONIC BORE GAUGE 94873 - Manual (Page 5)

Page 5 SKU 94873 for technical questions, please call 1-800-444-3353.
Start measuring the work piece. Tap the RAN Button twice, note the display symbol. 6.
Sweep the Electronic Bore Gauge back and forth in the bore; note the minimum
data on the display.
To calculate the dimension of the work piece: take the dimension of the outside 7.
micrometer and subtract the minimum data of the work piece and the minimum
data of the micrometer.
for common usage:
Insert the Electronic Bore Gauge into the bore to be measured. Press the ZERO 1.
Button. This will initialize the standard mode. Gently sweep the Electronic Bore
Gauge back and forth in the test bore to lock on to the diameter.
Remove and then insert the Electronic Bore Gauge into the next test bore. Follow 2.
the procedure in step #1 and repeat the measuring steps in this section.
plEasE rEad tHE following carEfully
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS qUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS qUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
parts list
part description Qty
1 Head 2
2 Shaft 1
3 Grip 1
4 Locking Screw 1
5 Display 1
6 Anvil Locking Nut 1
part description Qty
7 Anvils (various sizes) 14
8 Washers 3
9 Guide Device 1
10 Contact Point 1
11 Large Anvil Fitting 1