Hearth and Home Technologies 7100 - Manual (Page 11)

7
Exhaust Hood
Your range is equipped with a two speed range hood that may be either vented directly to the outside, or may be
installed ventless. A set of exhaust filters are included with your hood. The filters should be cleaned periodically in
soapy water. Extras are available from your dealer or directly from Heartland Appliances Inc. Please order 4 or more
filters at one time to save freight and handling charges. Phone your dealer for pricing and ordering instructions.
Ventless Installation
Your unit is already set up for ventless operation. Cooking fumes are drawn through the filters and exhausted thru
the rear of the hood, back into the room. Install the exhaust filters in their location under the cabinet by first removing
the light lens. Then on one side, insert one of the filters into the grooves (front and rear of the cabinet) and slide
into place. Repeat these steps for the second filter
Figure 6
Exhaust venting
options
.
Vented Installation, Tools, Material, and Dimensions
Tools required to install vented hood:
Hammer
Slot screwdriver
Pliers Electric drill
Measuring tape Drill bits
Sabre saw OR Keyhole saw
Materials Required:
Duct—enough to go through wall or attic to outside. Elbows as required.
Roof cap or wall venthood
Caulking to seal around duct
Sheet metal screws
The above are standard parts and are available at any hardware store or heating contractor.