Heath Zenith Wireless Push Button Accessory SL-6290 Series - Manual (Page 2)

-2- 595-5507-11
2.
Set the push button jumpers to match the chime receiver
code. See “Code and Tune Setting” section.
1.
Install alkaline type A23 12 volt push
button battery. Remove back of case
by pushing in tab on bottom with a
small screwdriver. Make sure battery is
oriented properly (see page 5).
4.
Mount push button.
Use either screws or double sided tape
to mount push button.
To mount with screws, remove back of
case by pushing in tab on bottom with a
small screwdriver.
Attach back of case to door jamb or wall.
Snap front of push button on.
When attaching push button using double
sided tape, make sure the surface of the door jamb or wall is
clean.
3.
Test range. Temporarily position push button where you want
it mounted. Press push button to verify chime and push button
work properly. If chime does not sound, see Troubleshooting.