Husqvarna 965 610901 - Manual (Page 10)

10
ASSEMBLY
7
INSTALLING BAGGER MOUNT
6
TRIMMING MIDDLE CHUTE
1. Using the hacksaw, trim along the dashed line.
2. Locate the middle chute, flat washer, hood latch,
weld nut, lock washer and machine screw from kit.
3. Install in the appropriate hole at the upper end of
the middle chute, according to deck size.
Trim Line
Hood Latch
Weld Nut
Machine Screw
Lock Washer
Latch Location
Flat Washer
7
INSTALLING MIDDLE CHUTE
1. Place middle chute over the top end of the blower
assembly.
2. Latch middle chute to blower assembly.
Middle Chute
Blower Assembly
Using hardware provided in kit, attach support 1.
mount to unit.
Attach hanger bracket to support mount. Do not
2.
fully tighten nuts at this time.
Hanger Bracket
Secure rear end of support straps to outside of 3.
hanger assembly. Set reinforcement plates to the
outside of the tank brackets and fasten front end
of support strap to tank bracket and reinforcment
plate with round head bolt. Secure front end
of reinforcement plate to tank bracket with hex
bolt. Fully secure all mounting hardware. See
illustration.
NOTE: Rear guard hole may need to be drilled out
to 5 /
16
" if kit hardware is too large.
Support Mount
Support Straps
Reinforcement Plate
Hex Bolt Placement
Round Head
Bolt Placement