Husqvarna 965 610901 - Manual (Page 11)

11
Remove plastic end caps from the center bag 1.
support arm. Fully insert spacer plug into the end
of the support tube. It may be necessary to tap
the spacer into place with a hammer or mallet.
Replace the plastic end cap back over the spacer.
The additional extension will hold the hood more
securely when latched.
10
INSTALLING SPACER PLUGS
ASSEMBLY
3½ Bolt
Weight Bracket
Weight Plate
1. Bolt cast weight to weight brackets using 3 /
8
-16 x
1¼ bolts and four nuts.
2. Slide both weight brackets over the front tube on
the frame. Be sure to position the weight assembly
in the center of the frame.
3. Secure with 3 /
8
-16 x 3½ bolts and four nuts.
Front Tube
CAUTION
DO NOT operate mower with grass
catcher without front weight installed.
NOTE: Assistance from another person may ease
mounting the cover assembly to mower.
1. Lift and rotate cover to align the cover brackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
8
INSTALLING WEIGHT KIT
9
MOUNTING COVER ASSEMBLY
Remove center
end cap
Insert spacer and
replace cap