Hitachi VT-FX601A - Manual (Page 6)

PRECAUTIONS - 6 -
product.
18. Servicing
-Do not attempt to service this VCR yourself as opening or removing
covers may expose you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.
19. Damage Requiring Service
-Unplug this VCR from the wall outlet and refer
servicing to qualified service personnel under the following conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the VCR.
c. If the VCR has been exposed to rain or water.
d. If the VCR does not operate normally by following the operating instructions. Adjust
only those controls that are covered by the operating instructions as an improper
adjustment of other controls may result in damage and will often require extensive work
by a qualified technician to restore the VCR to its normal operation.
e. If the VCR has been dropped or damaged in any way.
f. When the VCR exhibits a distinct change in performance-this indicates a need for
service.
20. Replacement Parts
-When replacement parts are required, be sure the service
technician has used replacement parts specified by the manufacturer or have the same
characteristics as the original part. Unauthorized substitutions may result in fire, electric
shock or other hazards.
21. Safety Check
-Upon completion of any service or repairs to this VCR, ask the
service technician to perform safety checks to determine that the VCR is in proper
operating condition.
22. Heat
-This VCR should be situated away from heat sources such as radiators, heat
registers, stoves, or other products (including amplifiers) that produce heat.
PRECAUTIONS
LOCATION
For safe operation and satisfactory performance of your VCR, keep the following in
mind when selecting a place for its installation:
• Shield it from direct sunlight and keep it away from sources of intense heat.
• Avoid dusty or humid places.
• Avoid places with insufficient ventilation for proper heat dissipation. Do not block the
ventilation holes at the top and bottom of the VCR. Do not place the unit on a carpet
because this will block the ventilation holes.
• Install unit in a horizontal position.
• Avoid locations subject to strong vibration.
• Do not place the VCR near strong magnetic fields.
• Do not move the unit from a cold to a hot place or vice versa.
• Do not place the VCR directly on top of the TV.
POWER SUPPLY
• AC 120V, 60Hz ONLY