Homelegance DW15-PFE2S - Manual (Page 19)

Switching the dishwasher ON
End of programme
Six beeps will indicate that the wash cycle has finished and all the programme indicators light.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set main switch “A” to OFF.
Open the door .
Turn the water tap off. (Does not apply when Aquastop unit has been fitted)
Remove dishes, etc. when they have cooled down.
Turn on the tap.
Set ON-OFF button “ A ” to ON. All the programme
indicators “J1,J2,J3,J4,J5,J6 ” light .
Press programme button “I1” , programme indicator
“ J1” blinks and the time-remaining indicator “ F ” dis-
plays the time of the programme..
If the door is closed, after 5 seconds, the programme
indicator “ J1” bcomes to light and the dishwasher
beeps one time , then the programme starts
automatically.
A
I1
J1 J2 J3 J4 J5 J6
F
18
Interrupping the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.