H-P Products Electric Powerhead Electroglide - Manual (Page 11)

ELECTROGLIDE 11
MAINTENANCE AND CARE
Belt Replacement
(continued)
5. Tilt cover to back. Press cover
firmly until side tabs snap into
place. Replace cover screws,
light bulb and light cover.
Brush Replacement
1. Remove the Electroglide
Powerhead cover, belt and
brush assembly.
2. Remove brush supports,
washers, screws, end brush,
and brush sprocket pieces from
ends of brush assembly.
3. Reassemble brush assembly as
shown below.
4. Replace belt, brush assembly,
Electroglide Powerhead cover,
light bulb and light cover.
Replace brushes when the brushes
are worn to the level of the base
support bars.
Base Support Bars
Brush
Support
Washer
Brush
Sprocket
Flange
Brush
Sprocket
End
Brush
Washer
Brush
Support
Screw
Screw
Brushes
Brush Dowel