H-P Products Electric Powerhead Electroglide - Manual (Page 5)

ELECTROGLIDE 5
Before assembling your Electroglide Electric Powerhead,
be sure you have all parts shown in PARTS AND FEATURES.
1. Connect the upper and lower wand
sections. (The wand swivel is located
on the lower wand.)
2. Slide the upper and lower wands together
until the wand button snaps into place.
Turn wand button to the slotted area of
the wand swivel. (The swivel allows
you to turn the handle to the left side to
reach farther under low furniture.)
3. Insert the wand assembly into the wand
socket located on the neck of the
electric powerhead. The lower wand
button lock will prevent the wand
assembly from detaching from the
Electroglide while in use.
4. Plug the power cord from the wand
assembly into the receptacle at the top
of the upper wand. DO NOT FORCE.
5. Secure the electric cord into the cord
holder on the wand swivel.
6. Insert the hose handle into the wand
assembly. Insert the hose wall adapter
into the vacuum inlet valve. Plug the
120V power cord into the nearest
electrical outlet.
To remove wands, disconnect the power cord
and step on the wand release pedal, then pull
up on the wands.
WARNING
Do not plug into electrical supply until assembly is complete.
Failure to do so could result in electrical shock or injury.
ASSEMBLING VACUUM SYSTEM
Handle
Button
Hose
Handle
Wand Easy
Release Pedal
Wand
Button
Lower
Wand
Cord
Holder
Upper
Wand
Button
Lock
Wand
Swivel
Power
Cord
Plug
Holder
Suction
Control