Maintenance – Harbor Freight Tools 92061 User Manual
Page 5
SKU 92061
Page 5
For technical questions, please call 1-800-444-3353
Select and install the desired lense.
1.
The lenses are stored in a compartment at the bottom of the flashlight, under
the compass. Open this compartment by turning the cap counterclockwise.
2.
Select the desired lense. NOTE: Your preference may vary, but suggested
lens application is: RED for very low light output, GREEN for low light output,
YELLOW for contrast in haze or fog, FROSTED for diffused light.
3.
To change or install the lense, remove the
lense cover by turning counterclockwise.
Replace the existing lense with the desired
lense. Replace the lense cover, and tighten by
turning clockwise until finger tight.
To operate the flashlight:
1.
To turn on the flashlight, press the upper
part of the ON /OFF switch down.
2.
To turn off the flash light, press the lower
part of the ON / OFF switch down.
3.
To manually blink the flashlight, press the round “blink” button and release.
Maintenance
1.
When not in use, turn OFF the flashlight to save the
batteries.
2.
If the flashlight will not be used for several months,
remove the batteries before storage to prevent
possible damage caused by leaking batteries.
“blink” button
ON / OFF switch