Huawei DiGi Broadband HSDPA USB E219 - Manual (Page 14)

Failure to observe these instructions could result in your RF exposure exceeding the
relevant guideline limits.
Regulatory Information
The following approvals and notices apply in specific regions as noted.
CE Approval (European Union)
The wireless device is approved to be used in the member states of the EU.
The wireless device complies with the essential requirements and other relevant
provisions of the Radio and Telecommunications Terminal Equipment Directive
1999/5/EC (R&TTE Directive).
Federal Communications Commission Notice (United States): Before a wireless
device model is available for sale to the public, it must be tested and certified to the
FCC that it does not exceed the limit established by the government-adopted
requirement for safe exposure.
The SAR limit adopted by the USA and Canada is 1.6 watts/kilogram (W/kg)
averaged over one gram of tissue. The highest SAR value reported to the FCC for
this device type was compliant with this limit.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
* This device should be installed and operated with a minimum distance of 20 cm between the radiator and
your body when using it via USB cable.
10
1. Click the Network Type tab
2. In the Network Type drop-down combo box, select the corresponding network type
3. In the Band down-drop list box, select the corresponding frequency band
4. Click Apply
5. Click OK to save and enable the settings
Selecting a Registration Mode
You can set the search and registration mode after selecting the network type.
1. Click the
Registration Mode tab
2. Select Auto search and register or Manual search and register
Auto Search and Register
When you select
Auto search and register, the terminal product can automatically
search and register to a supplied network.
Manual Search and Register
1. Select
Manual search and register
2. Click Refresh
3. Select an operator name in the list
4. Click
Register
Connection Profile Settings
To display the Dial-Up interface, do as follows:
1. Choose Tools > Options
2. In the navigation tree, click Profile Management
3. Click the Dial-Up tab
8