HP C5100 User Manual
Page 27
Solution
The HP All-in-One might not respond if you press the
On
button too quickly. Press
the
On
button once. It might take a few minutes for the HP All-in-One to turn on. If you press
the
On
button again during this time, you might turn the device off.
Warning
If the HP All-in-One still does not turn on, it might have a mechanical failure.
Unplug the HP All-in-One from the power outlet and contact HP. Go to:
If prompted, choose your country/region, and then click
Contact HP
for information
on calling for technical support.
I connected the USB cable, but I am having problems using the HP All-in-One with my
computer
Cause
The USB cable was connected before the software was installed. Connecting the
USB cable before prompted can cause errors.
Solution
You must first install the software that came with the HP All-in-One before
connecting the USB cable. During installation, do not plug in the USB cable until prompted by
the onscreen instructions.
Once you have installed the software, connecting your computer to the HP All-in-One with a
USB cable is straightforward. Simply plug one end of the USB cable into the back of your
computer and the other into the back of the HP All-in-One. You can connect to any USB port
on the back of your computer.
For more information on installing the software and connecting the USB cable, see the Setup
Guide that came with the HP All-in-One.
The display shows the wrong language
Solution
You can change the language settings at any time from the
Preferences
menu.
To set your language and country/region
1.
Press
Setup
.
2.
Press to highlight
Preferences
, and then press
OK
.
3.
Press to highlight
Set Language
, and then press
OK
.
4.
Press to scroll through the languages. When the language you want to use appears,
press
OK
.
5.
When prompted, press to highlight
Yes
or
No
, and then press
OK
.
Chapter 2
24
HP Photosmart C5100 All-in-One series
Troub
leshoo
ting and su
pport