Harbor Freight Tools CENTRAL MACHINERY 95668 User Manual
Page 17
SKU 95668
For technical questions, please call 1-800-444-3353
PAGE 17
2.
Place the required spacers, also called Rub Collars (98, 99, 100), onto the
Spindle (105).
(See Figure V.)
RUB cOLLARS
(98, 99, 100)
SPINDLE (105)
cUTTER
(NOT INcLUDED)
FIgURE V
3.
Install the Safety Washer (97) and Upper Spindle Nut (96) securely. Tighten the
Upper Spindle Nut with an open-end wrench while holding the Spindle (105) at
the top with the provided Arbor Wrench (146).
(See Figures W and X.)
4.
Check to make sure the Cutter (not included) will rotate in the correct direction.
SAFETY WASHER (97)
UPPER
SPINDLE NUT
(96)
FIgURE W
ARBOR WRENcH
(146)
UPPER
SPINDLE NUT
(96)
FIgURE X
Setting Spindle Height:
1.
Correct Spindle (105) height is crucial to most shaping applications. Make sure
to use a piece of scrap wood to confirm the correct Spindle height before cutting
expensive lumber.
2.
Loosen the Spindle Hand Knob (92) located on the side of the Wood Shaper.
(See Figure Y, next page.)
3.
Move the Spindle Height Knob (120) to the right to raise the Spindle (105) or to