Harbor Freight Tools CENTRAL MACHINERY 95668 - Manual (Page 26)

SKU 95668 For technical questions, please call 1-800-444-3353 PAGE 26
TROUBLESHOOTINg
Problem Possible Reason Possible Solution
The Wood Shaper does
not start
or the circuit breaker
trips.
1. Electrical supply
circuit has low
voltage or high
resistance.
1. Make sure machine is
plugged into
a working, 110 volt,
grounded,
electrical outlet.
The Wood Shaper runs
slow.
1. Electrical supply
circuit has low
voltage or high
resistance.
2. The V-Belt is
slipping.
1. Make sure machine is
plugged into
a working, 110 volt,
grounded,
electrical outlet.
2. Adjust V-Belt tighter, or
replace Belt.
The Wood Shaper
vibrates. The
Spindle is loose. Or the
Cutter
“chatters”.
1. The Stand of the
Wood Shaper
is unstable and
wobbles.
2. The Spindle or
Cutter is loose or
out of alignment.
3. The Wood Shaper
has a loose
Motor or Spindle
Cartridge.
1. Stabilize the Stand on the
floor.
2. Reinstall the Spindle and/or
Cutter.
3. Have a qualified service
technician
check Motor and/or Spindle
Cartridge.
The Forward/Reverse
Switch does
not operate properly.
1. Defective Forward/
Reverse
Switch.
1. Immediately turn off
machine and unplug it
from its electrical outlet.
Do not operate
machine until a qualified
service
technician repairs or
replaces
Forward/Reverse Switch.
The Power Switch does
not turn off
Machine.
1. Defective Power
Switch.
1. Immediately unplug
machine from its
electrical outlet. Do not
operate machine
until a qualified service
technician repairs
or replaces Power Switch.