Honeywell MAGICSTAT 3355 - Manual (Page 10)

10 69-1012
Step 4: Program Thermostat
After the batteries are installed, the thermostat
can be easily programmed in your hand, before
it is installed on the wall.
If you prefer to program the thermostat after it
is installed on the wall, skip to page 18, and
return later to this programming section.
The following Personal Programming Chart
(pages 12 and 13) can be helpful for planning
your program schedule of time and tempera-
ture settings for various times of the day.
Four time periods are available during week-
days — WAKE, LEAVE, RETURN, and SLEEP.
These periods can be seen individually on the
display as you press the SET SCHEDULE key.
WAKE is the time period you want the house at
a comfortable temperature when you get up and
while you get ready for work or school. When
deciding what time to set for your WAKE period,
include extra lead time, depending on the
outside temperature and your furnace response
time, to give the furnace a head start to heat the
house before you get up. (This will be a higher
temperature during heating season, or a lower
temperature during cooling season.)
LEAVE is the time period you can set for an
energy-saving temperature while you are away
at work or school. (This will be a lower tem-
perature during heating season, or a higher
temperature during cooling season.)
RETURN is the time period you want the
house at a comfortable temperature for
activities before bedtime. When deciding what
time to set for your RETURN period, include
extra lead time, depending on the outside
temperature and your furnace response time,