Husqvarna SG13A - Manual (Page 38)

38
MAINTENANCE
Removing and refitting the wheels
To remove the left wheel (8) from the stump grinder,
remove the locking collar (9), the 1/4” screws (10),
the 1/4” hex nuts (3), the springs (4) and the brake
pad (7). The wheel can now be removed from the
axle.
To remove the right wheel (2), remove the locking
collar (1) and slide the wheel off the axle.
8011-217chg
LEFT
RIGHT
FRONT
WARNING!
Hold the teeth (30-31) in place as in the upper
diagram when mounting the pockets (32-33). Risk
for incorrect assembly.
Insert the screw (34) in one pocket (32), through
the blade section (28) and out though the pocket
(33) on the other side.
Make sure that the roll pins in the back edge of the
teeth are seated against the back of the pockets.
This provides the correct gauging of the cutter edge.
Tighten the screws 120 - 150 ft/lbs. (162-203 Nm).
Insert a bar through the extra holes in the cutting
wheel to act as a stop when removing and
attaching the cutting teeth and bearings.
8011-216
The cutters can come loose from the
cutting wheel if the screws are not
sufficiently tight. Comply with the
recommended torque settings.