Hampton Direct U32 - Manual (Page 16)

16 U32-5 FPI Direct Vent Gas Insert
BAY LOUVERS
1) Install top louver by sliding the two bracket
clips into the brackets located on top of the
bay door. See below. The fi tted louver leaves
a small gap between faceplate bottom and
louver top.
Note: If any maintenance etc. must be done
in the fi rebox, fi rst remove the Bay
louvers and door.
OPTIONAL BAY TRIM
Attach the 4 supplied magnets, each to the
back of the top and bottom trim pieces (space
out evenly) and attach trim to the top and bot-
tom of Bay door.
2) Install bottom louver by sliding the two
bracket clips into the brackets located
underneath the bay door. Secure with 1
screw into each Bottom Louver Mounting
Bracket as per diagram below. Use the
bottom hole in the bracket.
OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the
fl ush front. The standard fl ush door and glass
must remain on the unit. Hook the top of the bay
door over the fl ush door fl ange and swing the
bottom against the bottom fl ange of the fl ush
door. Press down on the Bay Bottom bracket
and push in until it clips behind the bottom of
the fl ush front.
SIT Extension knobs for Bay Front only.
3) Slide the valve extension knobs onto the
valve knobs. Match each extension knob with
the corresponding valve knob. Extension
knobs are for Bay Front installations
only.
Removing Bay Door
To remove only the Bay Door - use a screwdriver
to unclip the Bay Bottom bracket from the fl ush
door and then swing up and unhook from the
top fl ush door fl ange.
To remove the Bay Door & the Flush Front
together, pull the hook from the slot in the
bottom door bracket under the unit (see Standard
Flush Door instructions above). Then pull the
Bay Door and Flush door out and lift off of the
fl ange at the top of the unit.
2) Install the Spring Hinges on the left and right
side of the bottom of the Firebox using 2
screws per hinge.
3) Place the Bottom Louver near the hinge. Flip
hinge over the Bottom Louver and secure
using 3 screws.
Bottom Louver
Hinge
Location
INSTALLATION