haier HEATED AIR SPRAY PACKAGE 237410 - Manual (Page 12)

Flushina
14.
15.
K E Y
A Bleed-type master air valve
C A i r l i n e
3 Fluid heater
6 a Pump air regulator
6 b Gun air regulator
9 3-way valve
1 3 Drain hose
4 4 Fluid regulator
4 5 F l u i d f i l t e r
4 8 Filter drain valve
For a first-time flush, trigger the gun, and circulate
the solvent for 20 seconds. 16.
For flushina after fluid, turn the 3-way
valve to Circulate. Trigger the gun periodically
whiie circulating the solvent. Periodically
turn the
3-way valve to Drain to flush out some dirty
vent. Flush until the system is clean. Repeat with
clean solvent, if necessary.
17.
18.
19.
Raise the suction tube out of the solvent, trigger
the gun, and run the pump until air comes from the
gun. Turn the 3-way valve to Drain, and run the
pump until all air is expelled.
20.
Release the trigger, and close the fluid regulator
(44) and the air regulators
Clean the filter screen, air cap, and fluid nozzle
separately.
Open the filter drain valve (48). Remove the filter
bowl, and reinstall the filter screen.
Thoroughly clean the inside and outside of the
suction tube.
You are now ready to prime the system with
another fluid or to store the system.
Fig. 10
--
1 1