Hawking Technology HWU8DD - Manual (Page 20)

20
protocol your network is set on. Note: If you do not have this
information please contact your system administrator for answers and
assistance.
- Select “ TKIP ” or “ AES ” mode from the “ Encryption ” drop down menu
depending on what is used in your specific network.. WPA , WPA PSK ,
WPA2 or WPA2 PSK encryption modes will use TKIP or AES.
- Select “ WPA Encryption Settings ” in Figure 2-2 to enter the “ WPA
Settings ” page shown in Figure 2-5.
- After selecting the Authentication Protocol (i.e. WPA or WPA2) you must
select “ TLS ” or “ PEAP ” from the “ Protocol” drop down menu . If TLS is
selected, the User name and Certificate of your network will be required
to connect to a WPA/TLS enabled network. If PEAP is used, the User
name , Password and Certificate need to be used for authentication to a
specific network.
- If you selected the pre-share-key (WPA PSK or WPA2 PSK) protocol, you
can enter your password in the “ Passphrase ” field for access to the specific
network . If the ASCII format is checked, the password length can be
selected from 8 bytes to 63 bytes depending on the user and network
settings. If you check the Hexadecimal format, 64-bit characters must be
keyed in.
1.6 Using Profiles
Profiles can be used to save the connection and authentication settings of previously
connected networks. These profiles can be accessed at a later time when the network is
present by simply loading a saved profile:
- Select the profile that has been saved previously from the “ Profile name ”
drop down menu, then press the “ Load ” button to load the previously saved
profile.
- Write the profile name in the “ Profile name ” field , and press the “ Save
Current ” button to save the current status of the profile.
- Select the profile name that you wish to delete from the “ Profile name ” drop
down menu, and press “ Delete ” button to delete it