Harley-Davidson 74298 - Manual (Page 15)

Assembly
TM
24
• Slide the right and left handlebars through the holes in
the front fork.
• Align the screw holes in each handlebar with the screw
holes in the face of the front fork.
• Insert a screw through the front fork and into the lower
hole in each handlebar . Tighten the screws with a
Phillips screwdriver. Do not over-tighten.
• Insert a screw through the front fork and into the upper
hole in each handlebar . Tighten the screws with a
Phillips screwdriver. Do not over-tighten.
• Tighten the screws using a Phillips screwdriver. Do not
over-tighten.
2
1
Front
Fork
Left
Handlebar
Right
Handlebar
15
• Fit a handgrip on the end of each handlebar.
• Note the R (right) and L (left) markings on the handlebars.
Note: If it is difficult to slide the handgrips onto the
handlebars, moisten the inside of the handgrips
with water.
23
Handgrip
Handgrip
Handlebars
“R” “L”
TM
• Slide the fork axle up into the bottom of the front fork,
through the neck and steering stop, and out the top of
the front fork.
• Fit a .354 (small diameter) retainer on the end of the
fork axle.
• Support the fork axle and tap the retainer with a hammer
to secure it on the end of the axle.
• Pull on the .354 retainer to make sure it is secure on the
fork axle.
Fork Axle
Front
Fork
.354 (Small
Diameter)
Retainer 22
2
1