Home Theater Direct MX-500 - Manual (Page 23)

7. Press the START button on both units to begin cloning.
It will take about 40 seconds to complete the cloning and it
will flash Ò GOODÓ upon completion of the cloning.
8. Exit from the Cloning mode by pressing the MAIN
button and then exit from the SETUP mode by pressing the
MAIN button once again.
Pressing the MAIN button and Up on the joystick
simultaneously will make the LCD contrast darker and
pressing the MAIN button and Down on the joystick
simultaneously will make the LCD contrast brighter.
1. Go to the SETUP mode by pressing the MAIN and
ENTER buttons simultaneously for three seconds.
2. Press the CLONE button next to the LCD screen.
3. Press either the SEND or RECV button depending upon
the role of the remote control. If the MX-500
TM is to be
copied from, press the SEND button. If it is to be copied to,
press the RECV button.
4. If you wish to clone the entire device, press the ALL
button. If you wish to clone only one device at a time, press
the DEVIC button.
5. If you press the DEVIC button, it will show all the
devices. Press the device button you wish to clone.
6. Set the MX-500
TM head to head with another MX-500 TM
to be cloned from as shown below. Each unit should be in
either cloning from or cloning to mode based on the above
steps.
12. Cloning MX-500ª 12. Cloning MX-500ª
13. Adjustment of LCD Contrast
OSDOSD
O N O N OSDOSD
44 43