Honeywell TS815 - Manual (Page 17)

33
33
ACCESSING TEMPERATURE AND HUMIDITY WINDOW
Press UP or DOWN until the IN icon
on the upper right will flash.
VIEWING REMOTE (CHANNEL) TEMPERATURE AND HUMIDITY
Static Display:
In Temperature and Humidity Window, press the CHANNEL button to recall
a different channel.
Channel Auto-Scan Display:
To enable automatic scan of the different channels, press and hold CHANNEL,
until the 3 icon is displayed. Each valid channel will be alternately displayed
with a 5 seconds delay.
NOTE: the channel auto-scan feature can be active only if there are more than
one remote sensors operating and are set to different channels.
RECALLING TEMPERATURE AND DEW POINT INFORMATION
In Temperature and Humidity Window press SET button recalling either:
• Temperature and relative humidity
• Dew point and relative humidity
PROGRAMMING TEMPERATURE IN CELSIUS OR FAHRENGEIT
In Temperature and Humidity Window, press and hold SET to toggle the
temperature in Celsius (ºC) or Fahrenheit (ºF).
ACTIVATING OR DEACTIVATING ALARMS
In Temperature and Humidity Window, press the ALARM to recall a current
temperature for the corresponding channel, the upper temperature alert with
▲icon (if disabled, displays OFF), or lower temperature alert with ▼ icon (if
disabled, displays OFF).
34
Once the above alerts are displayed, press the UP or DOWN to enable or
disable the corresponding alert.
PROGRAMMING ALARMS
• In the Temperature and Humidity Window, press ALARM selecting
the desired alarm.
• Press and hold ALARM button until the remote temperature and ▲or
▼ icon starts flashing.
• Adjust the temperature digits for the Temperature Alarm using the UP
or DOWN. Press and hold either button for fast digits advance
• Press the ALARM to confirm selection and return to the temperature
alarm selection screen
VIEWING REMOTE TEMPERATURE AND HUMIDITY MAX/MIN READINNGS
In the Temperature and Humidity Window press the MEMORY button
recalling:
• Current temperature and humidity
• Minimum temperature and humidity
• Maximum temperature and humidity at the remote location.
RESETTING REMOTE TEMPERATURE AND HUMIDITY MEMORY
In the Temperature and Humidity Window, press and hold MEMORY button
to clear memory for all channels.
REMOTE SENSORS STATUS
The wave icon above the current channel icon shows the connection status of
the corresponding remote sensor:
Icon Status