Honeywell TS815 - Manual (Page 19)

37
37
speed or wind gust speed)
• Press and hold ALARM button until speed digit will flash.
• Set the alarm using the UP or DOWN. Press and hold either button for
fast digits advance.
• Press ALARM to confirm your selection and return to the high wind
alarm selection screen.
MAINTANANCE
CHANGING BATTERIES
The battery status of each weather sensor is checked every hour. If the low
battery indicator lights up, replace the batteries in the corresponding unit.
CHANGING BATTERIES IN THE MAIN UNIT
• Remove the battery compartment door from the back and replace
batteries. Do not mix old and new batteries
• Replace the battery compartment door
CHANGING BATTERIES IN REMOTE SENSORS
• Replace the batteries following the setup instructions for the
corresponding sensor
• When the batteries are properly installed, the remote weather sensor
will resume sending signals to the main unit
• To enforce an immediate remote signals search, press and hold
DOWN on the main unit
CLEANING
The main unit and outer casings of the remote weather sensors can be cleaned
with a damp cloth. Small parts can be cleaned with a cotton tip or pipe-cleaner.
38
Never use any abrasive cleaning agents and solvents. Do not immerse any
units with electronic parts in water or under running water.
WIND METER
Check if the wind cups can spin freely and are free from dirt, debris and spider
webs.
TROUBLESHOOTING
Check here before contacting customer service.
Issue Symptom Solution
Main unit US Atomic Time signal is
not received Place unit by the window and keep it
there overnight
Main unit The weather readings
weather station are
different from the TV, radio
or official weather reports The weather data may vary
considerably due to different
environmental conditions and
placement.
Check the placement tips included in
this manual to site your weather
sensors in the best possible way.
Check batteries
Cannot locate remote
sensor
Check location
Press and hold DOWN ( ▼) button on
the main unit to search for the signal
form the remote sensor
Cannot change the
channel Press “RESET” after setting the
channel
Cannot change the C° to
F° and back Press “RESET” after setting C/F
Remote sensor
Data does not match data
on the main unit Initiate manual sensor search (Press
and hold DOWN ( ▼) button on the
main unit)
PRECAUTIONS
This product is engineered to give you years of satisfactory service if handled
carefully. Here are a few precautions:
• Do not immerse the units in water.