Heath Zenith DUAL BRITE 598-1041-04 - Manual (Page 5)

5 598-1041-04
SYMPTOM
Light stays
on continu-
ously.
Light flashes
on and off.
Light does
not stay on in
M a n u a l
mode.
POSSIBLE CAUSE
1. The sensor may be picking
up a heat source like an air
vent, dryer vent, or brightly-
painted heat-reflective
surface.
(Reduce
sensitivity).
2. Light control is in Manual
Mode. (Switch to Auto.)
3. Light control is in Dual
Brite™ mode.
1. Sensor is in the Test mode.
(While in TEST mode, light
only stays on for 5 seconds.)
2. Heat being reflected from
other objects may be
affecting the sensor.
(Re-
aim sensor.)
1. Nearby large, light-colored
objects reflecting light may
trigger the shut-off feature.
Do not point other lights at
the sensor.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulb is loose or burned
out.
3. Fuse is blown or circuit
breaker is turned off.
4. Daylight turn-off is in ef-
fect (recheck after dark).
5. Incorrect circuit wiring, if
this is a new installation.
1. Light Control may be in-
stalled in a relatively dark
location.
2. Light Control is in Test.
(Set control switch to an
ON-TIME position).
1. Light Control may be sens-
ing small animals or
automobile traffic
(Reduce
sensitivity).
2. Sensitivity is set too high.
(Reduce sensitivity.)
SYMPTOM
Light will not
come on.
Light comes
on in day-
light.
Light comes
on for no ap-
parent rea-
son.
TROUBLESHOOTING GUIDE
If you experience a problem with your lantern, follow this guide before returning it to the
retailer.
See your Canadian Tire retailer for warranty information.
No Service Parts Available for this Product