Harbor Freight Tools 94683 User Manual
Page 11
SKU 94683 For technical questions, please call 1-800-444-3353 PAGE 11
INSPECTION, MAINTENANCE, AND CLEANING
1.
CAUTION! Make sure the Power Switch is in its “OFF” position and
unplugged from its Charger (6) before performing any inspection,
maintenance, or cleaning of the Bug Vacuum.
2.
Before each use, inspect the general condition of the Bug Vacuum. Check
for misalignment or binding of moving parts, damaged or loose parts, dirt or
debris in the Vacuum Filter and Mesh Screen, damaged electrical wiring, and any
other condition that may affect the tool’s safe operation. If abnormal noise or
vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.
To clean: Flush the interior and clean the exterior of the Bug Vacuum
accessories with a mild detergent. Then, allow to air-dry. Do not use solvents.
Do not immerse the Vacuum (1) in liquids.
4.
When storing: Always completely empty the Bug Vacuum of dirt, debris, and
insects. Make sure to store the Bug Vacuum and its accessories in a safe,
dry, clean location out of reach of children and other unauthorized people.
5.
To remove the internal NiCd battery: A technician should unthread the front
portion of the Vacuum (1) and set it aside. Then, the four screws in the rear por-
tion should be removed. The battery pack can then be removed and a replace-
ment installed and sauter-connected to the wires. Always dispose of or recycle
used NiCd batteries properly. For information on free battery recycling, please
call 1-800-444-3353.
6.
CAUTION! All maintenance, service, and repairs not discussed in this
manual should only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
REV 08/06