Harbor Freight Tools 91523 - Manual (Page 13)

SKU 91523 PAGE 13
3. Before the first use, remove the Fuel Tank Cap (33) and fill the Fuel Tank (30) with
nleaded gasoline.
Then, replace the Fuel Tank Cap. Thereafter, check the
Engine’s Fuel Gauge (34) for the amount of unleaded gasoline in the Fuel Tank. If
necessary, refill the Fuel Tank with unleaded gasoline; the Generator must be
turned off and cooled down before refilling the fuel tank. (See Figure C.)
To Start The Engine:
1. Make sure the electrical powered tools/equipment that will be used are not
plugged into the Generator while the Engine is started.
2. Turn the 120 volt AC Circuit Breaker (5) to its “ON” position. (See Figure D.)
3. Open the Fuel Valve (40). (See Figure E.)
OFF
ON
CIRCUIT BREAKER
(5)
FIGURE D
OFF
ON
CLOSED OPEN
FUEL VALVE (40)
CHOKE LEVER
(21A)
FIGURE E
4. Close the Choke Lever (21A) to about 1/8” clearance. (See Figure E.)